Edge Ultrasound System Betriebsanweisung PDF herunterladen (Seite 105)

Chapter 6: Troubleshooting and Maintenance 93

Troubleshooting

To clean and disinfect a transducer (wipe

method)

1 Disconnect the transducer from the system.

2 Remove any transducer sheath.

3 Clean the surface using a soft cloth lightly

dampened in a mild soap or detergent cleaning

solution to remove any particulate matter or

body fluids.

Apply the solution to the cloth rather than the

surface.

4 Rinse with water or wipe with water-dampened

cloth; then wipe with a dry cloth.

5 Mix the disinfectant solution compatible with the

transducer, following disinfectant label

instructions for solution strengths and

disinfectant contact duration.

6 Wipe surfaces with the disinfectant solution.

7 Air dry.

8 Examine the transducer and cable for damage

such as cracks, splitting, or fluid leaks.

If damage is evident, discontinue use of the

transducer, and contact SonoSite or your local

representative.

To clean and disinfect a transducer

(immersion method)

1 Disconnect the transducer from the system.

2 Remove any transducer sheath.

3 Clean the surface using a soft cloth lightly

dampened in a mild soap or compatible cleaning

solution to remove any particulate matter or

body fluids.

Apply the solution to the cloth rather than the

surface.

4 Rinse with water or wipe with water-dampened

cloth, and then wipe with a dry cloth.

5 Mix the disinfectant solution compatible with the

transducer, following disinfectant label

instructions for solution strengths and

disinfectant contact duration.

6 Immerse the transducer into the disinfection

solution not more than 12-18 inches

(31-46 cm) from the point where the cable

enters the connector.

Follow the instructions on the disinfectant label

for the duration of the transducer immersion.

7 Using the instructions on the disinfectant label,

rinse to the point of the previous immersion, and

then air dry or towel dry with a clean cloth.

8 Examine the transducer and cable for damage

such as cracks, splitting, or fluid leaks.

If damage is evident, discontinue use of the

transducer, and contact SonoSite or your local

representative.

Cleaning and disinfecting the battery

To clean and disinfect a battery (wipe

method)

1 Remove the battery from the system.

Caution:

Do not allow disinfectant to contact

metal surfaces. Use a soft cloth

lightly dampened in a mild soap or

compatible cleaning solution to

remove any disinfectant that

remains on metal surfaces.

Caution:

Attempting to disinfect a

transducer or transducer cable

using a method other than the one

included here can damage the

transducer and void the warranty.

Caution:

To avoid damaging the battery, do

not allow cleaning solution or

disinfectant to come in contact

with the battery terminals.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 197 198

Kommentare zu diesen Handbüchern

Keine Kommentare

Edge Ultrasound System Betriebsanweisung Seite 105

Kommentare zu diesen Handbüchern

Související produkty a manuály pro ne Aeg-Electrolux KFA78DIM