Edge CTS Bedienungsanleitung PDF herunterladen (Seite 9)

HARDWARE INSTALLATIONS

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

Figure 7 - PROBE INSTALL

2) Make sure that the probe

cable is positioned to allow best

path and no bending when rout-

ing to the ﬁ re wall.

NOTE: The probe will move

approximately 90 Deg. clock-

wise in the direction the nut

is tightened. Before fully

tightening the nut, make sure

the cable starts 90 Degrees

from the ﬁ nal resting position.

When tightened the cable will

be correctly positioned. (Figure

Figure 8 - 90 DEGREE

CAUTION: Do not bend

the probe after installed. If

needed, loosen the probe nut,

adjust the probe, and re-tight-

en. Bending the probe tubing

will result in a faulty probe.

(Figure 9)

Starting Position

Tightened Position

90 Deg.

To Fire wall

Figure 9- DO NOT BEND

Wrong

Correct

Fitting

Flush

Nut

Probe

Wrong

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Keine Kommentare

Edge CTS Bedienungsanleitung Seite 9