Edge CTS Bedienungsanleitung PDF herunterladen (Seite 28)

MYSTYLE SOFTWARE

Installation Instructions

28

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

8) Click the button on the right

labeled “Customize EAS De-

vices”. The following screen

will appear:

Figure 47

9) Use the scroll bar to scroll

down to the different options if

more than one is available.

Choose this Icon if you

want to rename and

change the description

of your Edge EGT Probe.

Choose this Icon if you

want to change multiple

parameters on your EAS

Universal Sensor Input Device.

UNIVERSAL SENSOR INPUT

Previously in the Universal

Sensor hardware install section

of this manual, it explained that

you will need to pay attention to

the letter on the connectors.

“A” = Sensor A

“B” = Sensor B

The following describes each

feature in Figure 48 (next page).

These descriptions apply to both

Sensor A and B conﬁ gurations:

1 S/N: The serial number of

your EAS device.

2 Gauge Name: The name

that will be displayed on the

CS/CTS gauge screen.

3 Long Name: The name that

is shown in the PID selection

menu on the CS/CTS.

4 Description: Will be

displayed in the “More Info”

menu on the CS/CTS.

5 Mapping: Choose custom

or pick from any of the

default sensors already

provided

6 Pull-up Value: This option

can only be used in custom

mapping.

7 Alert: The alert allows you

to set a maximum or

minimum value that will

trigger a PID alert.

8 Units: The unit of measure-

ment for your particular

sensor. An example would

be “psia” for an Absolute

Pressure Sensor.

9 Input Table: These tables

cannot be edited unless

custom mapping has been

chosen.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare